Name: Gc Elite 100 Zinc Phosphate Cement
Availability: InStock

Elite 100 is unbeatable in terms of its physical properties such as strength, film thickness and low solubility. It complies with ADA Specification (Type 1, fine grain) and is registered in the certified ADA listings.

INDICATIONS

Cementation of crowns, bridges and inlays.

ADVANTAGES

High Film Thickness Low solubility

Key Specifications

COMPOSITION

POWDER	% by wt	LIQUID	% by wt
zinc oxide	88	phosphoric acid	50-60
magnesium oxide	12	water	37
		aluminium	3

powder to liquid ratio	1.45g / 0.5mL.
mixing time	60-90 sec
working time from start of mixing	3-4 minutes
setting time from end of mixing time	7 min 10 sec

STORAGE

Store at temperature of 4-25°C (39.2-77.0°F).

CONTRAINDICATION

1. Pulp capping.

2. In rare cases the product may cause sensitivity

to some persons. If such reactions are

experienced, discontinue the use of the product

and refer to a physician.

CAUTIONS

In case of contact with oral tissue or skin, remove immediately with a sponge or cotton soaked in alcohol.
Flush with water.In case of contact with eyes, flush immediatelywith water and seek medical attention.
Do not store with eugenol cements

Packaging

1 x 35g Powder
1 x 30g Liquid

Direction to Use

STEP1. POWDER AND LIQUID DISPENSING

a) The standard powder to liquid ratio is 1.45g / 0.5mL. b) For accurate dispensing of powder, lightly tap the bottle against the hand. Do not shake or invert. c) Close bottles immediately after use.

STEP2. MIXING

a) Dispense powder and liquid onto a heavy glass slab. b) Using a stainless steel spatula divide the powder into 3 equal portions. Incorporate one portion of powder into ALL the liquid and spatulate thoroughly for 10 seconds. Successively incorporate the remaining portions and spatulate thoroughly. The total process should take 60-90 seconds. Working time is 3-4 minutes from start of mixing (Temperature : 23±1°C, Relative humidity : 50±10%).

Note : The correct consistency is obtained when the mixture lifted with the spatula is drawn out into a slender peak, breaks and resettles slowly into the main mass.

STEP3. CEMENTATION TECHNIQUE

a) Prepare tooth using standard techniques. b) Clean with pumice and water only. Wash and dry but DO NOT DESICCATE. DO NOT REMOVE SMEAR LAYER. For pulp capping use calcium hydroxide. c) Clean and dry inside of casting. d) Mix the required amount of cement. e) Coat internal surface of restoration with 1mm of cement and start to seat within 30 seconds of completing mix. (DO NOT OVERFILL). Higher temperatures will shorten working time. f) Net setting time is 7 minutes 10 seconds from end of mixing. Remove excess cement at the first formation of gel stage.

Be the first to review “Gc Elite 100 Zinc Phosphate Cement”